Comfort

Comfort

Three dials, four switches. Set once, remembered on this device only.

60%
10 or below holds everything still. 100 = full physics. Collisions still land within 50 ms.
0%
Starts at 0. Unlocks on your first tap, never on its own.
75%
Strength of the six inks. 0 is grey. Each chip's name is in its label.

How a money counting machine works

Oddlyplay guide ยท the mechanics behind Note Counter

A desk money counter works by pulling notes off the bottom of the stack one at a time, counting each with a sensor as it whips past, and catching it in a spinning wheel that stops it dead on the pile. Note Counter is built step by step on that real machine, and Slow motion lets you watch it happen.

Watch it count

How does it pull just one note?

The stack sits in the hopper on top. Under it, an off centre roller with a grippy surface turns once per note and jogs the bottom of the stack to loosen it. A feed roller then pulls the lowest note toward a faster pair of rollers, and slippery flanges hold back the rest so only one goes through.

How does it count?

A sensor spots each note as it passes and the display counts up, the way real machines do, never down. Real ones often have a second small display facing the customer, and this one has it too.

Why do the notes stop so hard?

They leave the rollers at speed and get caught in a pocket of the stacker wheel, the spinning thing with curved blades at the bottom. It brakes each note in a very short distance, then strips it against a stop so it drops onto the pile. So the motion is a whip and a hard stop, never a gentle float.

How fast are real machines?

Common desk counters run around 1,200 to 1,500 notes a minute, and those are exactly the Real and Fast settings here. Slow motion uses the same physics at 4 notes a second.

Can I see inside the machine?

Yes. Press Inside above the picture for a side cutaway. The notes lie on a tilted tray, a lobed roller jogs the bottom ones loose, a feed roller pulls one through against a roller that holds the next back, a sensor counts it, and the stacker wheel catches it in a slot and strips it out onto the stack. Front and Inside are drawn from the same running machine, so you can switch in the middle of a count without losing your place.

Why does the motor keep humming after it stops?

Because it spins up quickly and runs down slowly, just like a real motor coasting to a halt.

Watch it count