Comfort

Comfort

Three dials, four switches. Set once, remembered on this device only.

60%
10 or below holds everything still. 100 = full physics. Collisions still land within 50 ms.
0%
Starts at 0. Unlocks on your first tap, never on its own.
75%
Strength of the six inks. 0 is grey. Each chip's name is in its label.

Why your 1TB drive shows up as about 931GB

Nobody stole any storage from you. A terabyte on the box is a decimal unit, exactly 1,000,000,000,000 bytes, while your operating system is quietly measuring and labeling in binary gibibytes, and those two scales drift further apart the bigger the number gets. Oddlyplay's unit converter keeps decimal and binary storage units separate on purpose so you can see both honestly, side by side.

Open the unit converter on Digital storage. It starts with 1 gigabyte filled in, and right there you will see it listed as about 0.931 gibibytes, not 1. Nothing is wrong, those are genuinely two different units for a very similar sounding name, and the converter is doing the honest thing by not pretending they are interchangeable.

Decimal against binary, the actual root of it

A kilobyte is 1,000 bytes, following the same metric rule that makes a kilometer 1,000 meters. A kibibyte is 1,024 bytes instead, because computer memory and storage addressing are built in powers of two, and 1,024 is 2 to the power of 10, the nearest convenient binary round number to 1,000. Both are correct definitions, they are just answering slightly different questions, and the gap between them compounds every time you go up a size.

So is my 1TB drive actually smaller than advertised

No, the drive genuinely holds 1,000,000,000,000 bytes, exactly what a decimal terabyte means, and that is the industry standard definition manufacturers build to. What happens next is that your operating system divides that same byte count using binary gibibytes instead of decimal gigabytes, and then, confusingly, often prints the result with a label that still just says "GB". Run the numbers and 1,000,000,000,000 bytes divided into gibibytes of 1,073,741,824 bytes each comes out to about 931.3, which is exactly the number people see and assume is missing storage.

Which one should I actually trust

Both, for different jobs. If you are comparing the capacity written on two different drive boxes, decimal gigabytes and terabytes are what the label uses, so compare those directly. If you are watching how much room is actually left on a drive that is already plugged into your computer, your operating system is almost certainly reporting binary gibibytes under a decimal looking label, so a drive reading "900 GB free" out of a 1TB drive is not lying to you, it is just using the other scale without saying so.

Does this affect internet speed too

Differently, but worth knowing. Internet speeds are measured in bits, not bytes, and almost always in decimal, so a connection sold as 100 megabits per second is 100,000,000 bits each second. Downloads measured in your browser are usually reported in bytes. Divide a bits per second speed by 8 to estimate bytes per second, and you will land roughly in the right place for how fast a download bar should be moving.

What does the converter actually list separately

Bits, bytes, decimal kilobytes through terabytes, and binary kibibytes through tebibytes, nine units in total in the Digital storage category, each one converting through the same exact byte count underneath so nothing drifts or gets rounded twice on the way.